Casting Crane | 4 Sets Double Girder Overhead Crane Supplier For Malaysia

4 Sets Double Girder overhead crane Supplier For Malaysia

4 sets of double girder overhead crane shipped to Malaysia in recent days. The Malaysia customer is doing steel business, and the crane is mainly used lift steel, cause the bad environment, our engineer designs the special material for the customer.

Casting crane in the bad environment of high temperature, high dust lifting liquid metal, the use of frequent, job level high. Mainly used for converter charging span to converter against the molten iron, in refining span will be hot metal lifting to refining furnace or in the molten steel will span steel continuous casting lifting to turn on the big. The common structure form has four main girder double car structures, double girder single car (a main, secondary hook) structure. The main lifting mechanism of two sets of drive mechanism (used in large tonnage crane) and single set of drive hook (for small tonnage crane).

The crane is applied in smelting mill for hoisting high temperature melting metal.

 Environment required of Double Girder Overhead Crane Supplier

① Environmental temperature for the crane is -10℃~+60℃.

② When temperature is +40℃, the relative humidity cannot be over 50%.

③ The height above sea level of the place where the crane is can not be over 2000m.

④ The power supply for the crane is 3 phases,50HZ,380V(or as regulated in contract).

⑤ There should not be flammable, explosive or causticity air at site.

⑥ The installation of the rails for the crane should accord with the regulations of GB/T10183-1988

Photos of Double Girder Overhead Crane Supplier For Malaysia

Features of Double Girder Overhead Crane Supplier For Malaysia

Main specifications
Rated capacity 30/15t Span /M
Working class A7 Lifting height 14/16m
Wheel base 5000mm Trolley gauge 2500mm
Max. wheel load 320.4KN Hook limit /mm
Structure
Main structure Box section Explosion- proof Not applicable
Control method Cabin Lifting tool Hook
Lifting specifications
Lifting ratio 4/3 Lifting motor YZR280M -6/225M-6
Lifting speed 10/12m/min Lifting power 63/30kw
Maximum capacity 30t Brake YWZ4-400/45、300/45
Working class M7 Braking torque 1000/630
Reducer ZQ850/650  

Transmission ratio

48.57/48.57
Drum diameter Φ650/500mm Fixed pulley diameter 680/560mm
Wire rope 22/16MM, steel core    
Crane travelling mechanism
Speed 60m/min Power 9KW
Working class M7 Brake type/Qty YWZ4-200/25/2sets
Motor Qty 2sets Braking torque 200N.M
Reducer ZQ500 Transmission ratio 40.17
Tread diameter of crane wheel Φ750mm Recommended rail QU70
 

Trolley travelling mechanism

Speed 30m/min Power 5.5KW
Working class M6 Brake type/Qty YWZ4-200/25/1set
Motor type/Qty 160M1-6/1set Braking torque 200N.M
Reducer ZSC600 Transmission ratio 37.9
Tread diameter of trolley wheel Φ350mm Trolley rail P38
                                                                                                                                                                     

Ambient environment

Power supply 400V Frequency 50Hz
Ambient temperature -10~40℃    
Standard
Design standard GB/T3811-2008 Fabrication standard JB/T1306-2008

 

15t double girder overhead crane for sale to Malaysia , used for steel casing construction project. Span: 24 meters, Lifting height: 18 meters, higher reliability, lower maintenance and equipment costs. For more information about DQCRANES and its full range of single or double girder overhead cranes, email to Philippines@cncranefactory.com.